Installation; Unpacking - Fri-Jado Bake Basic 3 - E Instrucciones De Manejo

Bake Basic 3/5 - E & P
3.

Installation

WARNING
• Have an authorised installer position and install the unit.
•
The unit weighs more than 60 kg. Make use of the proper lifting or hoisting devices.
• Install the oven in compliance with the applicable health and safety legislation
3.1.

Unpacking

1. Remove all parts from the unit.
2. Remove the foil from all metal parts.
3. Remove all packaging materials from the unit.
4. Check the unit for damage.
5. Make sure that all parts belonging to the model you
have ordered are present.
6. Read the manual before proceeding.
3.2. Installation
WARNING
• Have an authorised installer install the earthed wall socket that can provide the indicated
current.
• Make sure that the wall socket has been protected with an earth leakage switch (type K).
WARNING
• Position the unit flatly on a sufficiently sturdy base using a spirit level. For example, a solid
working bench. Take the weight of the unit into account.
• Make sure there is a clearance of 5 cm between the back and side panels and the walls or
other equipment.
• The opening between the unit and the base must be free from obstacles to ensure good
ventilation in the electrical compartment.
• Use the correct couplings for the water connection in order to prevent water leakage.
• If the oven has not been connected to an outlet channel, make sure there is at least
500 mm free space above the oven.
•
Allow for enough space for the oven, so you can easily place the baking trays into and take
them out of the oven.
Find a suitable place for the unit. Points of interest:
•
If the oven is installed on a base, the floor must be completely level. This facilitates a good operation
of the door lock.
• Make sure there is 900 mm free space on the front side of the oven for operation and maintenance
and for unloading products.
• The products in the unit must be well visible.
• Ensure the unit's accessibility for maintenance and service activities.
• Do not allow children on the service side.
• The unit is not suited for use in a rainy or very moist environment in view of danger of short circuit.
•
There must be a water supply connection with an aerated tap valve with a ¾ inch screw connection
nearby (P-model only).
•
The environmental temperature must be between 10 and 30 °C. The unit is not suitable for outside
use.
9123573_1007
en / 2-8