Beem CM4637AG-GS Manual Del Usuario página 27

27
Use the small sieve insert for individual pads (6). With E.S.E. (Easy Serving Espresso) pads,
make sure that you place them in the middle of the sieve insert.
2. Use the pressing aid (5) to press down the espresso / coffee powder in the sieve insert.
3. Remove excess espresso / coffee powder from the rim of the portafi lter or make sure that
the edge of the coffee pad does not protrude.
Filling the Sieve Insert for Capsules
Note that the sieve insert for capsules (10) must be fi lled before it is inserted in the porta-
fi lter (9).
1. Reach into the recess on the sieve insert for capsules and fl ip open the bottom part.
2. Insert the coffee capsule into the sieve insert.
3. Flip the bottom part of the sieve insert down again.
4. Insert the sieve insert into the corresponding portafi lter (see "Inserting / Removing the Sieve
Insert").
Inserting the Portafi lter into the Device
1. Hold the fi lled portafi lter (8, 9) fi rmly by the handle and insert it into the device under the
symbol.
2. Turn the portafi lter to the right (
Removing the Portafi lter from the Device
1. Hold the portafi lter (8, 9) by the handle and turn it to the left until it is under the
(Picture F).
2. Pull the portafi lter down out of the device.
Emptying the Sieve Insert for Powder and Pads
1. Flip up the small lever on the handle of the portafi lter (8). It stops the sieve insert (6, 7) being
able to fall out when it is emptied (Picture G).
2. Tap out the portafi lter over a dustbin.
3. Flip the small lever down again and remove the sieve insert from the portafi lter (see the
"Inserting / Removing the Sieve Insert" section).
4. Clean the sieve insert (see the "Cleaning and Care" chapter).
03260_03270_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 27 03260_03270_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 27
symbol (Picture E).
) until it is under the
EN
symbol
22.07.2021 11:30:53 22.07.2021 11:30:53