Beem CM4637AG-GS Manual Del Usuario página 35

35
Problem
Water runs out of
the device.
The espresso /
coffee runs along
the outside of the
portafi lter (8, 9).
Despite a pumping
noise, no water
comes out of the
device.
The espresso / coffee
runs very slowly into
the cup.
A large amount of
steam is produced in
the brewing process.
During use, an
unpleasant smell is
detected.
03260_03270_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 35 03260_03270_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 35
Possible cause
There is too much water in the
water tank (18).
The brewing position or steam
position has been set.
The drip tray (11) is full.
The portafi lter is not inserted
correctly.
The rim of the portafi lter
is contaminated with
espresso / coffee powder.
The coffee pad sits on the rim.
There is no water in the water
tank (18).
The water tank (18) is inserted
incorrectly.
The espresso / coffee powder is
pressed too fi rmly.
The espresso / coffee powder is
too fi nely ground.
The device is furred up.
The device is furred up.
The device is being used for the
fi rst time.
The device has previously been
descaled.
Fix
Do not overfi ll the water tank!
Always move the selector switch
to the position when there is
no vessel under the portafi lter
outlet or the steam nozzle (3).
Empty the drip tray.
Check that it fi ts correctly.
Clean the portafi lter and the
sieve insert (6, 7, 10).
Insert the coffee pad correctly.
Fill the water tank.
Take out the water tank and
insert it again. Make sure that it
fi ts correctly.
Only press down the espres-
so / coffee powder lightly.
Use espresso / coffee powder
with a coarser grinding fi neness.
Descale the device.
Descale the device.
A smell often develops when
new devices are fi rst used. The
smell should disappear once the
device has been used several
times.
Rinse out the device with clear
water.
22.07.2021 11:31:01 22.07.2021 11:31:01
EN