Note: The following instructions are accessed by pressing the buttons located on the Unit Control Panel. The same
instructions can be used via the remote control.
Power On/Off:
PMTS
Change Temperature Setting:
To Adjust Fan Speeds:
PMTS
Press the On/Off button
Press or hold either Left () or Right () button until the desired temperature
is seen on the display. This temperature will be automatically maintained
anywhere between 62° F (17° C) and 86° F (30° C).
If you want the display to read the actual room temperature, refer to the note
"To Operate on Fan Only".
Press to Raise Temperature
Press to Lower Temperature
Select the Fan Speed in four steps: Auto, Low, Med or High. Each time the
button is pressed, the fan speed mode is shifted. For some models, the fan
speed can not be adjusted under HEAT mode. On Dry mode, the fan speed
is controlled at Low automatically.
Press to select appropriate fan speed
- 12 -