To Use the Clean Air Feature (Only available on some models):
Displays
PMTS – Personal Mapping Temperature Sensor (E-Star models only)
PMTS
Press the Clean Air Button
Press the Clean Air button. The ion generator is energized and will help to remove
pollen and impurities from the air, trapping them in the filter.
The display panel shows the set temperature in Celsius or Fahrenheit and the Auto-
timer settings. While in Fan Only mode, it shows the current room temperature.
Error Codes:
AS – Room temperature sensor error - Unplug the unit and plug it back in. If error
repeats, call for service. Note: In Fan Only mode, it will display "LO" or "HI".
●
– Evaporator temperature sensor error-Unplug the unit and plug it back in. If
error repeats, call for service. NOTE:
HS – Electric heating sensor error-Unplug the unit and plug it back in. If error
repeats, call for service.
Light flashes on control panel when activated.
NOTE: This feature can only be activated from the remote control.
When activated, the remote control serves as a remote thermostat
allowing for the precise temperature control at the location of the remote
control.
To activate the PMTS feature, point the remote control towards the unit
and press the PMTS button. The remote displays the actual temperature at
the location of the remote control. The remote control will send this signal
to the air conditioner every 3 minutes until the PMTS button is pressed
again. If the unit does not receive the PMTS signal after more than 7
minutes, the unit will beep to indicate that the PMTS mode has ended.
●
is displayed as shown in the left picture.
- 15 -