Beem CM5403EA-GS Manual página 31

31
Inserting / Removing the Sieve Insert
Insert the corresponding sieve insert (b / c) into the portafi lter (d). When you insert it,
•
make sure that the small locking lug on the sieve insert fi ts in the recess on the portafi lter.
Otherwise the sieve insert cannot be inserted (Picture B).
• To remove the sieve insert from the portafi lter, turn the locking lug on the sieve insert
towards the recess on the portafi lter. Then pull the sieve insert out upwards.
Filling Sieve Inserts
1. After inserting the sieve insert in the portafi lter (d) (see "Inserting / Removing the Sieve
Insert"), use the measuring spoon (a) to fi ll it with espresso / coffee powder.
With espresso / coffee powder, make sure that the sieve insert is not overfi lled (note the
MAX marking)!
2. Use the pressing aid (a) to press down the espresso / coffee powder in the sieve insert.
3. Remove excess espresso / coffee powder from the rim of the portafi lter.
Inserting the Portafi lter into the Device
1. Hold the fi lled portafi lter (d) fi rmly by the handle and insert it under the label
into the portafi lter mount (9).
2. Turn the portafi lter to the right until it is under the label
Removing the Portafi lter from the Device
1. Hold the portafi lter (d) by the handle and turn it to the left until it is under the label
INSERT.
2. Pull the portafi lter down out of the device.
Emptying the Sieve Insert
1. Flip up the small lever on the handle of the portafi lter (d). It stops the sieve insert (c) being
able to fall out when it is emptied (Picture C).
2. Tap out the portafi lter over a dustbin.
3. Flip the small lever back and remove the sieve insert from the portafi lter (see the "Inserting /
Removing the Sieve Insert" section).
4. Clean the sieve insert (see the "Cleaning and Care" chapter).
INSERT
LOCK.
EN