Troubleshooting - Beem CM5403EA-GS Manual

39
Storage
Disconnect the device from the mains power when you are not going to use it for a prolonged
period. Clean the device again if necessary (see the "Cleaning and Care" chapter) and let it dry
completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact our customer
service department.
Do not attempt to repair an electrical device yourself!
Problem
The device cannot be
switched on. /
The fi eld (4) does
not light up.
The fuse in the fuse box
is triggered.
The brewing process
cannot be started.
Water runs out of the
device.
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
There is no mains voltage.
The fi eld has not been
touched.
Too many devices connected to
the same circuit.
The device has not yet reached
the correct brewing temperature.
There is too much water in the
water tank (h).
The steam power control (1) is
not in the position.
The drip tray (e) is full.
Fix
Correct the fi t of the mains plug.
Try another plug socket.
Check the fuse of the mains
connection.
Touch the fi eld to switch on
the device.
Reduce the number of devices in
the circuit.
Wait until the device has heated
up or cooled down suffi ciently.
You can speed up the cooling
process by fl ushing through the
steam nozzle.
Pour a little water away.
Always move the selector switch
to the position when there is
no vessel under the portafi lter
outlet (d) or the steam nozzle (6).
Empty the drip tray.
EN