Before Initial Use; Setting Up And Connecting The Device - Beem CM5403EA-GS Manual

EN

Before Initial Use

1. Remove all packaging materials and any possible protective fi lms and / or transport protec-
tion. Never remove the rating plate and any possible warnings.
2. Wipe the device with a clean, damp cloth. Clean all accessories with a little detergent and
clear water.
3. Set up the device and connect it (see the "Setting Up and Connecting the Device" chapter).
4. Before you enjoy your fi rst espresso or coffee, we recommend that you carry out a trial run
to remove any possible production residues on the device and in the water system. To do
this, follow the instructions in the "Handling and Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
5. Repeat this process twice. Do not drink this espresso / coffee!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).

Setting Up and Connecting the Device

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed. The plug socket
must also be readily accessible after connection so that the connection to the mains can
quickly be isolated. The mains voltage must match the technical data of the device.
• Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
• Do not use the device in conjunction with extension cables.
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
1. Place the device on the kitchen unit or another dry, clean work surface, following the safety
notices and the notices provided at the beginning of this chapter.
2. Insert the mains plug into a properly installed plug socket that is easily accessible.
The fi eld (4) lights up. The device is in stand-by mode.
28