Mounting The Power Cord Bracket; Placing The Grease Tray; Attaching The Hopper Clean-Out Door Knob; Mounting The Hopper Handle - Pit Boss PLATINUM BRUNSWICK PBV5PL Instrucciones Y Recetas

5. MOUNTING THE POWER CORD BRACKET

Parts Required:
1 x Power Cord Bracket (#14)
2 x Screw (#C)
Installation:
• Locate the two holes on the Back-Left Support Leg. Mount the power
cord bracket to the Back-Left Support Leg using two screws.
• Fully-tighten all screws on the cart base. Next, carefully turn the unit
into an upright position, with the wheels on the bottom.

6. PLACING THE GREASE TRAY

Parts Required:
1 x Grease Tray (#9)
Installation:
• Slide the Grease Tray into the grease tray brackets on the back
underside of the Main Cabinet.
NOTE: The Grease Tray is completely inserted once the front of the
tray is flush with the back of the Main Cabinet.

7. ATTACHING THE HOPPER CLEAN-OUT DOOR KNOB

Parts Required:
1 x Door Knob (#A)
Installation:
• Attach the Door Knob to the hopper clean-out door by rotating the
part into the hole on the door. Rotate until completely fastened and
clean-out door latch is secured.
NOTE: To use the hopper clean-out feature, simply loosen the door
knob, raise the clean-out door latch and open the door.

8. MOUNTING THE HOPPER HANDLE

Parts Required:
1 x Lid Handle (#6)
2 x Screw (#D)
Installation:
• Located the hopper on the backside of the unit. Mount the Lid Handle
onto the Lid of the Hopper using two screws.
5
14
6
9
7
8
D
C
A
6
9