PROPAIN Trickshot Manual De Instrucciones página 12

// BEFORE YOUR FIRST RIDE
Before your first ride, check all basic functions of your bike to ensure that there are no assembly errors or transport damages. If there are any defects or faults, your bike must be checked by a trained
bicycle mechanic and the defects must be eliminated. Never ride with a defective bike!
Lift the front and rear wheel one after the other and turn the wheels.
WHEELS / TIRES
→ The wheels must turn smoothly.
→ The wheels must turn straight, without lateral or vertical runout.
→ The tires must not rub against the frame.
Check the tire pressure.
→ The tire pressure should be about 2 bar. The maximum tire pressure of the wheel and the tire used must not be exceeded.
Check the tightening torque of the axles.
→ The thru axle of the front wheel must be tightened to 2.2 Nm and the bolts of the dropouts of the fork to 2.2 Nm
→ The axle nuts of the rear wheel must be tightened with 18 Nm!
Verify the tight fit of the stem: Stand in front of the bike, clamp the front wheel between your knees and try to twist the handlebars.
COMPONENTS
→ It must not be possible to twist the handlebar with normal force.
Check the headset for play: Stand next to your bike, pull the front brake lever and gently push the bike backwards and forwards.
→ No bearing play must be detectable.
Make sure that all components are tight.
→ Loose components must be tightened to the required torque. In case of doubt, contact the Propain Service.
Check the frame for damages and deformation.
FRAME
→ There must be no damages.
Sit on the bike with all your cycling equipment (helmet, backpack, shoes, etc.) and take a normal riding position.
FORK
→ We recommend a SAG of 15% - 20% on the fork
→ If necessary, change the air pressure of your fork.
Check brake efficiency: While standing, pull both brake levers in succession and move the bike back and forth.
BRAKES
→ The front and rear wheel must lock when the brake is applied.
Check brake hoses and connections for brake fluid leakage and defects.
→ No brake fluid may leak at the hose connections.
Brake in the brake pads. Choose a road away from public roads and brake 20 to 30 times with the front or rear brake from a speed of 30 km/h down to 5 km/h. Braking should be as
hard as possible without locking any of the wheels. Then repeat the procedure for the second brake. Only then the brake can develop its full braking force.