Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador página 49

CONTACT
20(COS2) 22(COM) Connector (NC contacts) for connecting mechanical closing limit switches (FC).
21(COS1) 22(COM) Input (NC or 8 kOhm) for connecting sensing edge.
23(ST) 22(COM) STOP command input (NC).
24(ANT) 25
27(ORO) 26(COM)
28(AP) 32(COM) Open control signal input (N.O.).
29(CH) 32(COM) Close command input (N.O.).
DESCRIPTION
N.B.: Each motor is equipped with an open limit switch and a closed limit switch. Con
to the limit switches
FC ≤5 cm
warping.
N.B.
procedure must be repeated (chapter 8).
– . Movement is reversed if the sensing edge (NC contact) is activated during
door closure.
parameter .
The current manoeuvre is arrested if the safety contact opens.
N.B.: the controller is supplied with this contact already jumpered by ROGER TECHNOL
OGY.
N.B.
Connector (NC contacts) for connecting mechanical opening limit switches (FC).
FA
closing limit switches of the MOTOR 2 in series
Adjust the door closed limit switch of MOTOR 1 (and MOTOR
is activated when the door reaches a distance no greater
than 5 cm from the door closed stop.
the manoeuvre is completed.
stops.
direction.
WARNING! The pressure exerted against the stop is
determined by the parameter
Adjust the door open limit switch so that the overhead
door stops after activation of the limit switch and
before the door open stop.
reverses direction.
N.B.
repeated (chapter 8).
. This value must be set in
21(COS1) - 22(COM) or set the
49