Travel Acquisition - Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador

10

Travel acquisition

1. Check the number of motors installed from the parameter
.
2. Check that the operator present function is not enabled (
3. Press TEST (see TEST mode in chapter 7) and check the command signal and safety device states. If any safety
).
4. Check that the limit switches are set correctly. Check the door closed limit switch in particular.
5. Check that the motors are connected correctly.Both motors must rotate in the same direction.
ACQUISITION PROCEDURE:
TEST
PROG
x4 s
OPENING OPEN
• Open the door into an intermediate position.
• Press and hold PROG for 4 seconds.
• Press PROG again. The acquisition procedure now starts. The message
• The door starts closing at low speed
at low speed. is shown on the display.
•
• The door closes until it reaches the door closed stop.
mode.
•
•
•
TEST
23
No
Yes
Yes
TEST
00
PROG
AP P-
AU to
is shown on the display.
. This parameter is set for two motors by default
).
See safety input (Chap. 13) and
Alarm and fault (Chap. 14)
CL OS
CLOSURE
CLOSURE CLOSED
appears on the display.
.
(
AU to
CLOSED
Yes
Yes
.
53