Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador página 65

15
TEST
x5 s
INFO mode may be used to view certain parameters measured by the B70/2B controller.
Press and hold the TEST button for 5 seconds from the "View command signals and safety devices" mode with the
motor stationary.
Parameter Function
.
View for 3 s
of the test.
current absorption.
settings of parameters
E.g. .
tion cable are inadequate for the installation or that the connection cable is too long or of inadequate cross
•
• Use the + -
the - button to return through the previous parameters.
•
• Press and hold the TEST button for a few seconds to exit INFO mode
and .
. = 0.12 s (120 ms). Ensure that the manoeuvre time is more than 0.3 s.
automation system opening (motor active).
automation system closing (motor active).
automation system completely open (motor not actives).
automation system completely closed (motor not actives).
mains voltage too low or overload.
motors overcurrent.
...
.
.
.
must always be lower than the value
TEST
TO QUIT
1 click
THE INFO MODE
.
65