Before Initial Use; Set-Up And Connection - Beem CM9402EB-GS Manual Del Usuario

19
NOTICE – Risk of Damage to Material and Property
• Switch off the device and pull the mains plug out of the plug socket if an error occurs during
operation, when there is a power cut or before a thunderstorm.
• When you pull it out of the plug socket, always pull on the mains plug and never the mains cable!
• Never pull or carry the device by the connecting cable.
• Do not pour very cold water into the hot water tank.
• Protect the device from other heat sources, fl ames, sub-zero temperatures, persistent moisture
and impacts.
• Never place any heavy objects on the device or the connecting cable.
• Use only original accessories from the manufacturer in order to guarantee that there is no
interference that may prevent the device from working and to avoid possible damage.

Before Initial Use

1. Wipe the device with a clean, damp cloth. Clean the thermal jug (6), the fi lter insert (10) and
the permanent fi lter (11) with detergent and warm water.
2. Set up the device and connect it (see the "Set-Up and Connection" chapter).
3. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run without
coffee powder to remove any possible production residues on the device and in the water
system. To do this, follow the instructions in the "Handling and Operation" and "Preparation"
chapters.
When the device is fi rst used, production-related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
4. Repeat this process twice. Do not drink this water!
5. Clean the device and accessories (see the "Cleaning and Care" chapter).

Set-Up and Connection

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed. The plug socket must
also be readily accessible after connection so that the connection to the mains can quickly
be isolated. The mains voltage must match the technical data of the device.
• Lay the connecting cable in such a way that it does not become squashed or bent and does
not come into contact with hot surfaces (also applies to the hot surfaces of the device!).
• Do not use the device in conjunction with extension cables.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
EN