Protool CCP 380 Manual De Instrucciones página 27

All manuals and user guides at all-guides.com
kniha_Narex_CPP380.book Seite 27 Mittwoch, 31. Oktober 2001 11:53 11
Defects and their removal
Defect
The machine will not run
The cut is not clean, the chain
goes to the side
Required big power to shift the
machine into the cut
The chain is not lubricated
Guarantee
We guarantee appliances in accordance with sta-
tutory/country-specific regulations (proof of
purchase by invoice or delivery note).
Damages attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of compliant please send the machine, un-
dismantled, to your dealer or the Service Centre
for electric power tools.
Cause Removal
Check safety fuses and supply
There is no current supply wires
Worn brushes Replace brushes
Stuck switch Press a safety fuse
When overloaded Check safety fuses
Too big shift into the cut Reduce the shift
Sharpen the chain, or replace it
Blunt tool with a new one
The chain is not properly
sharpened Replace the chain with a new one
Cutting without a stop gui-
dance Use the stop guidance
Supporting area of the Clean it and lubricate it with gliding
sleigh is dirty wax
Sharpen the chain, or replace it
Blunt tool with a new one
Adjust the size of the shift to the
Different qualities of wood cut
Too big shift for the cut Reduce the shift
Blocked lubricating chan-
nels of the guide reglet Clean the guide reglet
Replace the pump (in an authori-
Defected dose oil pump sed service workshop)
Empty oil tank Replenish chain oil
Inner oil channels of the Clean the machine (in an authori-
machine are blocked sed service workshop)
Declare of conformity
We declare under our sole responsibility that this
product is in conformity with the following stan-
dards or standardization documents:
EN 50 144-1, EN 55 014-1, EN 55 014-2,
EN 61 000-2-3, EN 61 000-3-3,
according to the provisions of the regulations
89/336/EEC, 98/37/EC
Manfred Kirchner
Subject to change
27