Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Place the grinder on the work surface.
ATTENTION! Be careful when handling or moving the appliance. Due to its weight (9
kg) and the rounded shape of the machine body, there is a risk that it may slip from
your grip.
4.4 Installation and connection to the electrical network
To complete the installation and start using your new coffee grinder, simply connect the plug to the
power outlet (Fig. 10).
If it is necessary to use power adapters, multiple sockets or extensions, it is essential to
use products that comply with the certification standards in force in the country of use.
•
If present, set the protection magnetothermic switch located upstream of the power socket to
the "ON" position (Fig. 11).
•
Turn the machine power switch to "ON" (Fig. 12).
At this point the coffee grinder is powered and ready to be used.
5
USING THE GRINDER
5.1 Preparing to use the grinder
Once the installation has been completed, the grinder is ready to use and can be loaded with the
coffee beans to be ground. With reference to Fig. 13, to load the coffee beans, proceed as follows:
•
Fit the hopper (Item 1) on the removable chamber (Item 2).
•
Make sure that the shutter (Item 3) is completely closed.
•
Remove the lid (Item 4) and fill the hopper with the roasted coffee beans to be ground.
•
Close the hopper with the relative lid (Item 4).
•
Gradually open the shutter (Item 3) to allow the flow of coffee beans into the grinding chamber.
•
At this point the grinder is loaded and ready to be used.
5.2 Selecting the grinding type
With reference to picture 14, select the type of grinding:
•
By turning the adjustment ring nut (Item 1), you can select the type of grinding desired between
"Filter", "Moka" and "Espresso".
•
The machine management screen, corresponding to the type of grinding selected, is displayed
automatically.
•
Select the grinding type by moving the sector of the ring nut corresponding to the "Filter",
"Moka" or "Espresso" adjustment to the red mark on the removable chamber (Item 2).
5.3 Machine controls
All the control devices on the grinder are described below.
40 / 102
Fiorenzato | Cod. AllGround_001 Ed. 01/2021
Publicidad
