Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the coffee dispensing tube (Fig. 29)
•
Hold the coffee dispensing tube (Item 1) and extract it from its seat to which it is connected
by means of a magnet coupling.
•
Wash the dispensing tube with hot water and a non-perfumed detergent and degreaser
with a neutral pH specific for the food sector.
•
Dry with a soft cloth.
•
With a vacuum cleaner and a dry cloth, clean the seat of the dispensing tube from all coffee
powder residues.
Cleaning the machine body (Fig. 30)
•
Cleaning the outside of the machine body must be done with soft cloths and products
suitable for the food sector.
ATTENTION! Do not use abrasive sponges and/or aggressive products that may
damage the external surfaces of the machine.
ATTENTION! It is forbidden to use jets of water or steam to clean the machine body.
Reassembling the grinder (Fig. 31)
After cleaning, reassemble the grinder:
•
Insert the coffee dispensing tube (Item 1) into its seat until it is attached to the magnet
inside the seat itself.
•
Insert the removable chamber (Item 2) into the machine body making sure to align it
correctly.
•
Fit the adjustment ring nut (Item 3) by acting as follows:
A
Position the adjustment ring nut (Item 3) on the machine body by aligning the red arrow
(Item 4) with the red reference notch on the removable chamber (Item 5).
B
Press the ring nut against the machine body and rotate it slightly anti-clockwise until the
coupling point is found. When the coupling point is reached, the locking pin (Item 6)
clicks upwards blocking the rotation of the ring nut.
C
Press the locking pin (Item 6) and turn the ring nut anti-clockwise again until it reaches
the desired working position.
•
Fit the hopper (Item 7).
The machine is ready to be used again after being supplied and refilled with coffee.
Fiorenzato | Cod. AllGround_001 Ed. 01/2021
EN
47 / 102
Publicidad
