Publicidad
Idiomas disponibles
Idiomas disponibles
7
ANOMALIES - CAUSES - REMEDIES
The table shows the possible anomalies that can cause a failure and/or irregular operation of the
coffee grinder. For each anomaly, the possible cause that generated it and the actions
to be taken to restore correct functioning of the appliance are indicated.
Anomaly
The grinder does
not turn on.
Coffee beans do
not descend from
the supply hopper.
The "Warning"
screen appears on
the display:
The motor stops
during grinding.
ATTENTION! If the anomaly persists even after carrying out the suggested corrective
actions, or if functional anomalies not listed in the table occur, contact a specialist
technician and have the appliance checked.
Fiorenzato | Cod. AllGround_001 Ed. 01/2021
Cause
No electric power.
Shutter closed too
much.
The adjustment ring nut
has been released from
its rotation lane and the
safety microswitch (see
Fig. 6 Item 1) does not
detect the removable
chamber in its correct
working position.
Motor protection thermal
cut-out intervention
due to blocking of the
grinding system in the
presence of objects or
foreign bodies between
the grinders.
Solution
•
Make sure that the switch is in the "ON"
position;
•
Make sure that the circuit breaker
upstream of the socket (if present) is in the
ON position.
•
Make sure that the power cord is intact
and that the plug is properly connected to
the socket.
•
Open the shutter.
•
Correctly tighten the adjustment ring
nut on its rotation lane following the
instructions given in the "Reassembling
the grinder" point of paragraph 6.1.1.
•
Turn off the appliance and wait for it to cool
completely.
•
Disconnect the appliance from the power
supply.
•
Close the shutter and remove the supply
hopper.
•
Open the removable chamber and clean
the grinders and remove any foreign
bodies.
•
Reassemble the appliance and start a
grinding cycle.
EN
49 / 102
Publicidad
