Publicidad
Idiomas disponibles
Idiomas disponibles
Follow these precautions to prevent personal injury during use and maintenance of this
equipment:
• It is the responsibility of the equipment
owner to perform a Personal Protective
Equipment Hazard Assessment to ensure
adequate protection during maintenance
procedures.
• Do Not Store Or Use Gasoline Or Other
Flammable Vapors Or Liquids In The
Vicinity Of This Or Any Other Appliance.
Never use flammable oil soaked cloths
or combustible cleaning solutions for
cleaning.
• All covers and access panels must be
in place and properly secured when
operating this equipment.
• Risk of fire/shock. All minimum
clearances must be maintained. Do not
obstruct vents or openings.
• Failure to disconnect power at the main
power supply disconnect could result
in serious injury or death. The power
switch DOES NOT disconnect all incoming
power.
• All utility connections and fixtures must
be maintained in accordance with the
authority having jurisdiction.
• Turn off and lockout all utilities (gas,
electric, water) according to approved
practices during maintenance or
servicing.
DANGER
• Units with two power cords must be
plugged into individual branch circuits.
During movement, cleaning or repair it is
necessary to unplug both power cords.
• Never use a high-pressure water jet for
cleaning on the interior or exterior of
this unit. Do not use power cleaning
equipment, steel wool, scrapers or wire
brushes on stainless steel or painted
surfaces.
• Two or more people are required to
move this equipment to prevent tipping.
• Locking the front casters after
moving is the owner's and operator's
responsibility. When casters are installed,
the mass of this unit will allow it to move
uncontrolled on an inclined surface.
These units must be tethered/secured to
comply with all applicable codes.
• The on-site supervisor is responsible for
ensuring that operators are made aware
of the inherent dangers of operating this
equipment.
• Do not operate any appliance with a
damaged cord or plug. All repairs must
be performed by a qualified service
company.
• Crush/Pinch Hazard. Keep hands clear of
moving components. Components can
move without warning unless power is
disconnected and all potential energy is
removed.
Publicidad
