Inserting The Upper Clamping Shell; Replacing The Clamping Shells; Clamping The Tube - Orbitalum RPG 3.0 Traducción Del Manual De Instrucciones Original

RPG 3.0, RPG 4.5 (S), RPG 8.6
8.3.2

Inserting the upper clamping shell

1. Place the upper clamping shell at the stop bolt (3).
2. Swivel the clamping shell around the stop bolt in the direction of the arrow until the unlock handle locks into place.
8.3.3

Replacing the clamping shells

1. To replace the clamping shells, pull at the unlock handles.
2. Remove the upper and lower clamping shell.
8.4

clamping the tube

WARNING!
[REV. 20210302] OC_RPG_L_BA_790038761_01__INH-02_EN
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X No damaged or deformed cutting tools (MFW) should be used.
X Firmly clamp the tube to be machined into the clamping unit.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X The inner diameter of the clamping shells must be identical to the outer diameter of the
tube to be machined. The specific inner diameter is specified on the clamping shells. The
outer diameter of the tube must be determined.
X Avoid tool breakage by ensuring low (measured) infeed (max. clamping thickness: 0.2 mm)
and correct setting of speed (see chap. 9.2, p. 65).
X Check that the tool holder (WH) and multifunctional tool (MFW) are seated firmly, and
tighten if required.
X Keep the clamping surface of the clamping jaws free of chips and dirt.
Setup and assembly
3
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
59