Publicidad
Idiomas disponibles
Idiomas disponibles
O R I G I N A L I N S T R U C T I O N
9. P RIMING
Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also be necessary to restore
the full stroke after considerable use, when the stroke may be reduced and fasteners are not fully placed by one operation of
the trigger.
9.1 OIL DETAILS
The recommended oil for priming is Hyspin® VG32 available in 0.5l (part number 07992-00002) or one gallon containers
(part number 07992-00006). Please see safety data below.
9.2 HYSPIN® VG 32 OIL SAFETY DATA
First Aid
SKIN:
Wash thoroughly with soap and water as soon as possible. Casual contact requires no immediate attention. Short-term
contact requires no immediate attention.
INGESTION:
Seek medical attention immediately. DO NOT induce vomiting.
EYES:
Irrigate immediately with water for several minutes. Although NOT a primary irritant, minor irritation may occur following contact.
Fire
Flash point 232°C. Not classifi ed as fl ammable.
Suitable extinguishing media: CO2, dry powder, foam or water fog. DO NOT use water jets.
Environment
WASTE DISPOSAL: Through authorized contractor to a licensed site. May be incinerated. Used product may be sent for
reclamation. SPILLAGE: Prevent entry into drains, sewers and water courses. Soak up with absorbent material.
Handling
Wear eye protection, impervious gloves (e.g. of PVC) and a plastic apron. Use in well-ventilated area.
Storage
No special precautions.
9.3 PRIMING PROCEDURCE
CAUTION - CONNECT AIR SUPPLY (this causes the piston to bottom, allowing more priming oil into the tool).
CAUTION - DO NOT OPERATE THE TRIGGER WHILE THE BLEED SCREW IS REMOVED.
CAUTION - All operations should be carried out on a clean bench, with clean hands, in a clean area.
CAUTION - Care MUST be taken, at all times, to ensure that no foreign matter enters the tool, or serious
damage may result.
Item numbers in bold refer to the General Assembly of Handle and Parts List on pages 21-22.
•
Prior to starting the priming procedure, obtain a suitable container to collect excess oil.
•
Disconnect the air supply and undo the intensifi er oil reservoir cap.
•
Top up the reservoir in the cabinet with VG32 Hyspin® priming oil to a level of 20 mm (0.8") below top of the reservoir.
Remove Bleed Screw 18 and associated Washer 19 from front of tool.
•
•
Connect the tool to the air supply.
•
CARE SHALL BE TAKEN TO ENSURE THAT THE BLEED HOLES ARE NOT DIRECTED TOWARDS THE OPERATOR OR OTHER
PERSONNEL.
•
Place tool handle over the container with bleed hole orientated towards the container and operate the trigger.
•
When oil is ejected from the bleed hole, release the trigger.
Operate trigger again, replace Bleed Screw 18 and Washer 19 at front of tool BEFORE releasing trigger again.
•
•
Disconnect tool from air supply.
•
Remove Bleed Screw 18 and Washer 19 from rear of tool.
•
Connect tool to air supply.
•
Cycle the trigger until oil is ejected from the bleed hole. Release the trigger and replace the Bleed Screw 18 and Washer
19 at the rear of the tool.
•
Repeat the trigger operating/releasing sequence, allowing a few seconds between cycles to allow priming oil to
circulate.
E N G L I S H
25
Publicidad
