TECNOMOTOR TM 514 Manual De Instrucoes página 105

Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar tecnomotor@tecnomotor.com.br
Below are some clean device images:
√
√
It is very important that the fluid and filter change is made according to the time of
use and specification informed by the equipment.
Never reuse the fluid or filter.
Always use ISO4113 calibration fluid indicated in the equipment manual.
If in doubt, refer to the equipment manual available in the software in the Help
menu.
Panel cleaning
To clean the equipment panel, use a soft cloth with alcohol.
Do not use solvents or abrasives as they may damage the label.
Safety cover cleaning
To clean the safety cover, use a soft cloth with alcohol.
Do not use solvents or abrasives as they may damage the transparency of the
cover.
Fluid tank ceaning
When changing the test fluid, a cleaning of the fluid tank must be performed. To
do this, the equipment should be reclined a little to the left side, so that the
impurities contained in the bottom of the tank can go to the drain. With the
equipment reclined, place a container at the tank drain outlet and wait for the fluid
to escape. If there is still dirt inside the tank, contact the Tecnomotor Technical
Assistance Service.
TM 514 – COMMON RAIL TEST
√
√
199