6.5 Dispensing coffee
Preparing the filter holder
6.5.1
Before filling the filter holder, make sure it is
empty and any previous coffee residue has been
removed.
• Fill the filter with a dose of ground coffee (approx. 6-7 g);
follow the procedures specified by the manufacturer of
the grinder-dispenser.
• Compress the coffee with the special press.
• Clean the rim of the ground coffee filter before attaching
the filter holder to the dispensing group.
• Hook the filter holder to the group without closing it too
tightly in order to prevent the gasket from wearing quickly.
6.5.2
AL version
Never perform the described operations with-
out coffee in the filter or without the filter
holder attached to the dispensing group. The
rapid upward movement of the lever may cause damage
to the appliance, individuals or property. The dispensing
time depends on the grind fineness and the amount of
coffee in the filter holder.
• Place the coffee cup under the
dispensing spout.
• Pull the lever all the way down.
• Wait a short time for the cof-
fee to be pre-infused (3-5 sec-
onds).
• Lift the lever until a certain re-
sistance is felt, then release it.
• Wait until the coffee has been
dispensed.
USER Manual
6.5.3
AEP version
• Place the coffee cup under the dispensing spout.
• Press
the
desired
switch; the coffee will begin being
dispensed, and it can be stopped
via the same switch once the de-
sired amount of coffee has been
dispensed into the cup.
SAE and DISPLAY versions
6.5.4
Do not remove the filter holder from the dis-
pensing group when coffee is being dispensed.
• Place the coffee cup under the dis-
pensing spout.
• Press the desired dose button, e.g.
and wait until the coffee is
dispensed (LED will light up).
• To stop the coffee dispensing
ahead of time, press the
button.
• When enabled, use the
ton to continuously dispense cof-
fee.
• Should an anomaly occur or the pushbutton panel freeze,
use the manual switch (17).
17
dispensing
or
but-
17
47
216
of