Cup Warmer; Al And Aep Versions; Sae And Display Versions; Programming The Cup Warmer On The Sae Version - Astoria Core600 AL Manual De Instrucciones

6.10 Cup warmer

For safety reasons, we do not recommend placing
cloths or other objects on the cup warmer shelf in
order to prevent the machine from overheating.
HIGH TEMPERATURE HAZARD: the cup warmer
can reach temperatures that may cause burns. Be
very careful.
Place the cups on the cup warmer shelf of the coffee machine.
1
The cup warmer temperature can be set according to personal
requirements. The procedure for activating and adjusting the
cup warmer according to the model in your possession, is de-
scribed below.

6.10.1 AL and AEP versions

To use the cup warmer, proceed as follows:
• Place the cups on the cup warmer shelf of the coffee ma-
chine.
• Turn the cup warmer switch to ON.
To adjust the cup warmer temperature, proceed as follows:
• Remove the cup holder grille and drip tray.
• Turn the thermostat (2); the temperature will be propor-
tional to the value indicated on the thermostat.
0 Cup warmer off
30 Minimum temperature
60 Average temperature
90 Maximum temperature

6.10.2 SAE and DISPLAY versions

To use the cup warmer, proceed as follows:
• Place the cups on the cup warmer (1) shelf of the coffee
machine.
• Select the cup warmer button on the pushbutton panel
.
The red colour on the display indicates that the cup warmer
is heating up.
USER Manual
6.10.3 Programming the cup warmer on
the SAE version
To adjust the cup warmer temperature, proceed as follows us-
ing the right pushbutton panel:
• When the machine is switched on, wait for all of the but-
ton LEDs to light up and then immediately press the
button: the flashing LED will indicate the current configu-
ration of the cup warmer, as shown in the diagrams below.
• Hold down the button until the LED on the panel
goes from a flashing to a steady light.
• Press the key that corresponds to the desired configuration.
• Confirm the operation by switching the machine off and
back on.
60°C
90°C
Cup warmer
100°C
6.10.4 Programming the cup warmer on
the DISPLAY version
To adjust the tempera-
ture of the cup warmer on
the Display model, see
chapter "6.12.4 Cup warmer tem-
perature" on page 53.
6.11 Programming the standby mode
(SAE version)
To put the machine in standby mode, i.e. switch it off whilst
keeping the pushbutton panel active, proceed as follows:
• Press the button on the right pushbutton panel and
the button immediately afterwards.
• The machine is in standby mode when the
ton's LED flashes.
• To exit the standby mode, press the
70°C 80°C
110°C
button.
Heating
up
51
2
but-
216
of