Publicidad
Idiomas disponibles
Idiomas disponibles
– By using certified anti-slip mats you can ensure a guaranteed
coefficient of sliding friction.
4.4.4 Operation of the ratchet
Lashing device basic position/ starting position
6. Open tensioning element
7.
Put slotted shaft
8. Lashing strap starting position
9. Caution: With ErgoABS, place strap below guide bolt!
Applying the lashing
10. Place the lashing on the load.
11. Hang fasteners securely in the lashing points.
Length adjustment of the lashing
12. Thread the loose end
2
and pull it through until the strap lies against the load.
Clamping the lashing device
13. Tighten (move the ratchet lever back and forth) until the desired
tension is achieved.
– There must be at least 1.5 windings, but no more than 3,
on the slotted shaft
min. 2 windings, but no more than 3.
– Tighten diagonal lashings hand-tight.
Secure clamping element
14. After lashing, pull the function slider
15. Turn the ratchet lever
4
slide
can engage in the safety recess (if available) or the
ratchet lever is parallel to the console. The slider must be fixed in
the toothed disc.
– The ratchet is now closed.
Loosen
e
16. Pull the function slider.
19
IV VII
7
, pull the function slider
5
in threading position for the loose end
1
into the opening
c
2
, for lashing straps with ABS-System
d
7
so far in the closed position until the
6
b
5
of the slotted shaft
6
.
a
6
1
b
Publicidad
