Glowforge Pro Guia Del Usuario página 29

Slide In the Crumb Tray
The black and metal crumb tray sits inside the bed of your Glowforge, supports the material you place
inside, and catches leftover print bits to keep your Glowforge nice and tidy. It has four little feet that rest
in four little dimples. The handle goes in front, and the feet go on the bottom.
Lift the lid of your Glowforge & lower the front door
Gently move the Laser Arm. ​ U sing two hands, gently push the laser arm away from you until
it's near the back of the unit.
Pick up the Crumb Tray. ​ P ick up the crumb
tray - make sure the handle is in front and the
wide black plastic strip is in the back.
Slide in the Crumb Tray. ​ S lide it in until you
feel the feet settle into the dimples in the base
of the Glowforge unit.
Make Sure the Handle is in Front. ​ C heck that the handle's in the front, and the wide black part
is in the back, just like the picture. Otherwise, you'll have mysterious printing problems, and feel
silly when we ask you if your tray is in backwards.
Close the Front Door
Copyright Glowforge, Inc. 2019
29