Glowforge Pro Guia Del Usuario página 38

Reinstall your crumb tray, close the front door, and turn on your Glowforge!
Instructions for ​ i nstalling your crumb tray​
Removing your Pro Shields (optional)
Turn off your Glowforge
Turn off your Glowforge using the power switch on the back. The lights and button should be off.
Lower the front door and remove the crumb tray
Lift the lid, then lower the front door. Lift the crumb tray slightly and slide it towards you to
remove it. Be careful not to tilt the crumb tray up, or it will knock into the laser arm and rails.
Leave the front door open.
Remove the front Pro Shield from the front door of your Glowforge
With the front door opened, turn the black finger screws on either end of the Pro Shield
counterclockwise to unscrew them, then lift the shield away from the front door.
Using two hands, gently pull the laser arm to the front of your Glowforge
This will expose the rear Pro Shield so you can easily remove it
Copyright Glowforge, Inc. 2019
are available if you'd like a refresher.
38