Glowforge Pro Guia Del Usuario página 53

Pack Accessory Box
Place the crumb tray, exhaust vent, and ring
clamps in your Glowforge Accessory Pack box
Pack the Unit Safely
It's important to package your Glowforge properly with the original boxes, foam blocks, and
important orange and red bits.
Place Red Strip on Both Rails
Push the laser arm to the back of the unit. Set
the red silicone strips on the rails near the center
of the unit with the knobby bit close to you as pictured.
Position Laser Arm
Slide the laser arm forward so that it's resting on
the silicone strips. You'll need to pick it up just a bit at
the front, then the back, like taking a baby
carriage up a curb.
Attach the Clip
The clip snaps onto the bottom of the laser arm
and pokes up into the metal plate. Align the left tab
of the clip with the hole on the right side of the plate,
then hook the back of the laser arm and pull the clip
towards you and up. (It's much easier than it sounds.)
When the clip is in place, the metal plate will no longer
slide from side to side.
Copyright Glowforge, Inc. 2019
53