Descargar Imprimir esta página

Glowforge Pro Guia Del Usuario página 36

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Using Your Glowforge Pro  
Be sure to review Laser Safety before operating your Glowforge Pro.  
Moving material through the passthrough slot 
● Your material must move from front to back.
● If your material is long enough to stick out either
end, make sure that you support it so that it the part
inside your Glowforge stays flat on the crumb tray.
● If you've made a lot of cuts, it can help to open the
lid and remove the pieces before you slide your
material along. (A little tape can work wonders here
to help you extract little pieces that are hard to pick
up otherwise.)
● When you're moving your material, It's ok to pull it from the back, and you can pull hard if you
need to!
● As you slide your material, you may need to adjust your supports -- make sure that your
material continues to lie flat on the crumb tray.
Pro Shields 
Installing and removing your Pro Shields 
Your Pro Shields finger-screw right into the front and back passthrough slots of your Glowforge Pro
to ensure that nothing - material or laser light - comes in or out when the slot is not in use.
The Pro Shields should always be installed except while the passthrough slot is in use. The Laser
Safety Officer (LSO) training provided to Pro customers has important information about the Pro
Shields.
Copyright Glowforge, Inc. 2019
36

Publicidad

loading

Este manual también es adecuado para:

PlusBasic