Glowforge Pro Guia Del Usuario página 37

Installing your Pro
Turn off your Glowforge
Turn off your Glowforge using the power switch on the back. The lights and button should be off.
Lower the front door and remove the crumb tray
Lift the lid, then lower the front door. Lift the crumb tray slightly and slide it towards you to
remove it. Be careful not to tilt the crumb tray up, or it will knock into the laser arm and rails.
Leave the front door open.
Install the front Pro Shield
● The front Pro Shield has a rectangular edge and six circular holes which align perfectly
with the screws already in the front door of your Glowforge.
● With the rectangular edge facing away from you, align the two black screws on the front
Pro Shield with the two open screw holes near the passthrough slot. The rectangular
edge of the Pro Shield should be facing the inside of the Glowforge as pictured.
● Using your fingers, screw the two black knobs clockwise to secure your Pro Shield.
Using two hands, gently pull the laser arm to the front of your Glowforge
This will expose the back of your Glowforge so you can easily install the back Pro Shield.
Align the back Pro Shield against the passthrough slot on the inside of the Glowforge
The back Pro Shield is an oval and has no screw holes aside from a black finger screw on
either end. Using your fingers, screw the two black knobs clockwise to secure your Pro Shield.
Copyright Glowforge, Inc. 2019
Shields
37