Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
REAR-Facing Installation Harness Mode
Britax strongly recommends that children should ride REAR-
facing until they exceed the weight or height limits specified.
Use REAR-facing only:
• with harness straps in closest
position below the child's
shoulders, and
• with children weighing 5 - 50
lb (2.3 - 22.7 kg), and
• when the top of child's head
is at least 1 in (2.5 cm) below
the top edge of headrest.
For models with anti-rebound
bar:
Follow the instructions on page
17 to attach the anti-rebound
bar to the child restraint before
installing.
Installation with Vehicle Lap-Shoulder Belt (Preferred Method)
1� Place child restraint
REAR-facing on the
vehicle seat so that the
car seat base is flat on
the vehicle seat and is
parallel to vehicle seat.
2� Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
3� Ensure that no more than 3 in
(7.5 cm) of base hangs over
front edge of vehicle seat.
18
Table of Contents
4� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
5� Route the vehicle lap-
shoulder belt through the
REAR-facing belt path
marked by blue labels.
6� Ensure the belt is not
twisted, then buckle the
vehicle seat belt.
7� Remove slack from the lap
part (A), then the shoulder
part (B) of the vehicle seat
belt.
8� Close the CLICKTIGHT
over the vehicle seat belt.
9� Ensure both red
CLICKTIGHT release
buttons are visible.
NOTE: If it is difficult to close
you may have locked your
vehicle seat belt or removed
too much slack.
3 in
3 in
Table of Contents
B
A
CLICK
19
Publicidad
