Publicidad
Idiomas disponibles
Idiomas disponibles
7� Route the lap vehicle belt
through the FORWARD-
facing belt path marked by
green labels.
8� Ensure the belt is not
twisted and fasten the seat
belt.
9� Push down into the middle
of the child restraint
with moderate force
(approximately 20.5
kg/45 lb), compressing
the vehicle seat while
tightening the vehicle belt.
NOTE: Make sure the
vehicle belt is locked as
directed by your vehicle
owner's manual.
10� Close the CLICKTIGHT
over the vehicle seat belt.
11� Ensure both CLICKTIGHT
release buttons are visible.
NOTE: If it is difficult to close,
you may have removed too
much slack.
12� Connect the top tether hook
to the vehicle's top tether
anchor (check the vehicle
owner's manual for location).
13� Pull the top tether strap to
remove slack and secure
excess webbing with the
elastic band attached.
30
Table of Contents
CLICK
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Vehicle belt is locked as directed by your vehicle owner's manual.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for FORWARD-facing,
after child is secured.
9 Child restraint cannot be moved front to back or side to side more than
1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 The anti-rebound bar MUST be removed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
BOOSTER Mode Installation
IMPORTANT:
Britax strongly recommends that children
should remain in a child seat with a 5-point harness until
reaching the maximum weight or height allowed.
Use in
BOOSTER
mode only:
• in recline position "B", and
• with children who weigh 40 - 120
lb (18.1 - 54.4 kg), and
• when top of child's ears are
BELOW the top of headrest, and
• when the lap belt sits low across
child's upper thighs when routed
through the belt guide, and
• when the vehicle shoulder belt lays straight across the
child's chest, and
• when the shoulder belt guides are positioned above the
child's shoulders.
Using Lower Anchors and Top Tether (LATCH) in BOOSTER Mode
Use of lower anchors and top tether is not required for
booster seat installation. However, lower anchors and top
tether can be used to secure child restraint in
mode. ALWAYS make sure the child restraint system is
secured to the vehicle, even when unoccupied, since in
a crash, an unsecured child restraint system may injure
occupants.
To use this seat in
BOOSTER
see instructions for Securing Your Child in
page 36.
Table of Contents
BOOSTER
mode without lower anchors,
BOOSTER
Mode on
31
Publicidad
