Publicidad
Idiomas disponibles
Idiomas disponibles
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing, after
child is secured.
9 Child restraint cannot be moved front to back or side to side more than
1 in. (2.5 cm) at the belt path.
9 Both vehicle lap and shoulder belts are routed through the CLICKTIGHT.
9 Excess top tether webbing is contained within your vehicle and secured.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
Installation with Lower Anchor Connectors (LATCH)
Do not install by this method for a child weighing more than
30 pounds (13.5 kilograms).
1� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
2� For models WITH storage
pouch only: Open the
storage pouch.
Remove the lower
connectors by pressing
the spring tab, pushing
the connector back while
rotating down and forward
off the anchor point.
3� Extend lower connector
strap to its longest
length by pressing grey
button on the lower
connector adjuster.
4� Place the child restraint
REAR-facing on vehicle
seat so that the car seat
base is flat on the vehicle
seat and is parallel to
vehicle seat.
5� Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
20
Table of Contents
Without
With storage
storage pouch
pouch
(Select Models)
6� Ensure that no more than
3 in (7.5 cm) of the base
hangs over the front edge
of the vehicle seat.
7� Slide the lower
connector strap into the
REAR-facing belt path
marked by blue labels.
8� Firmly press the lower
connectors onto their
adjacent lower anchors.
9� Ensure the connector
strap is not twisted. Pull
the end of the lower
connector strap to
remove slack.
10� Close the CLICKTIGHT
over the lower
connector strap.
11� Ensure both red
CLICKTIGHT release
buttons are visible.
NOTE: If it is difficult to close,
you may have removed too
much slack.
NOTE: Do not install by this method for a child weighing
more than 30 pounds (13.5 kilograms).
Table of Contents
3 in
3 in
ADJUSTMENT
SLOT
ADJUSTMENT
SLOT
21
Publicidad
