Descargar Imprimir esta página

Securing Your Child; Harness Mode - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

Ocultar thumbs Ver también para ONE4LIFE CLICKTIGHT:

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUSTMENT
SLOT
9 Child restraint is in recline position "B".
9 Child restraint is in a vehicle seat that has a lap-shoulder belt.
9 All connections are secure and strap is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 That any excess top tether webbing is contained within your vehicle and
secured.
9 If your vehicle seat back is adjustable, ensure it is in the upright position
before placing the child seat on the vehicle seat.
NOTE:
If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle. Ensure that the LATCH system
does not interfere with the vehicle belt function and
alignment when securing your child.
Please see section Securing Your Child in
Mode on page 36 to properly secure your child.

Securing Your Child

Harness Mode

1� Make the proper
adjustments to the harness
and buckle (page 12).
2� Loosen the harness. Press
the harness release button
(A) and pull both harness
straps forward (B).
34
Table of Contents
3� Open the chest clip by
4� Release the buckle and
5� Place child in the child
6� Position the harness
7� Fasten the buckle. Proper
BOOSTER
8� Check the proper harness
9� Pull the harness adjuster
B
A
10� Fasten the chest clip and
squeezing the tabs (A)
and pull apart (B).
place the harness straps
to the side.
restraint. Ensure the child
is positioned upright in
the child restraint and not
slouching. Their bottom
must touch the child
restraint, and their back
must rest flat against the
back of the child restraint.
straps around the child.
NOTE: Remove bulky coats,
jackets, and/or bulky sports
equipment before putting the
child in the child restraint.
connection is confirmed
with a click after inserting
each buckle tongue.
height and pull any excess
slack up to the child's
shoulder area before
tightening.
strap to tighten the harness.
NOTE: The harness should
have a snug fit around the
child. A snug strap should
not allow any slack. It lies
in a relatively straight line
without sagging. It does not
press on the child's flesh or
push the child's body into
an unnatural position. You
should not be able to pinch
excess webbing.
place at armpit level.
Table of Contents
B
A
CLICK
35

Publicidad

loading