Troubleshooting Tips - VALBERG 3S58 F WAD929C Instrucciones De Uso

C

Troubleshooting tips

Before calling for service
Reviewing the charts on the following pages may save you from calling for service.
Problem
• Dishwasher doesn't
start
• Water not pumped form
dishwasher
• Suds in the tub
Practical information
Possible Causes
• Fuse blown, or the circuit break
tripped.
• Power supply is not turned on.
• Error code:E1;
Water pressure is low
• Door of dishwasher not
properly closed.
• Twisted or trapped drain hose.
• Filter clogged.
• Kitchen sink clogged.
• Wrong detergent.
31
• Replace fuse or reset circuit
breaker.
• Remove any other appliances
sharing the same circuit with the
dishwasher.
• Make sure the dishwasher is
turned on and the door is closed
securely.
• Make sure the power cord is.
properly plugged into the wall
socket.
• Check that the water supply is
connected properly andthe water
is turned on.
• Make sure to close the door
properly and latch it.
• Check the drain hose.
• Check coarse the filter.
• Check the kitchen sink to make
sure it is draining well.If the
problem is the kitchen sink
that is not draining, you may
need a plumber rather than a
serviceman for dishwashers.
• Use only the dedicated
dishwasher detergent to avoid
suds. If suds exist in the washer.
Open the door for 20-30 minutes
to allow the foam to evaporate.
If the foam still exists in the
liner. Add 1.5L of water to the
liner, close the dishwasher door
and run a forced drain to drain
it with the water. Repeat above
operation until the foam is
cleared.
EN
What To Do