Descargar Imprimir esta página

Whirlpool WVH 92 K/1 Instrucciones De Uso página 58

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 99
● If the product is not equipped with a power cable, use one with a minimum
conductor diameter of 2.5 mm2 for power up to 7200 Watt; for higher power levels,
the diameter must be 4 mm2. ● The temperature must not reach 50°C above room
temperature anywhere along the cable. ● The product is intended to be
permanently connected to the mains, therefore, make the connection to the mains
using an approved omnipolar switch that guarantees complete disconnection from
the mains in category III overvoltage conditions, and which is readily accessible
after the installation.
● Please note! Before reconnecting the circuit to the mains power supply, make
sure that it is working correctly, always check that the power cable is correctly
installed.
● Please note! The interconnection cable must be replaced by the authorised
customer service representative or by a person with similar qualifications.
to connect the electrical appliance with the optional single-phase connection, the
existing power cord must be removed and replaced with another type of power
cord (not supplied) having the following specifications: single-phase
connection :cable H05V2V2-F 3G4.
ASSEMBLY
● Before starting the installation: After unpacking the product, check that it has
not been damaged during transport and in the case of problems, contact your
dealer or Customer Service, before proceeding with the installation; Check that the
purchased product is the right size for the installation location; Check for
accessories inside the packaging (placed there for ease of transport, such as bags
containing screws, the warranty certificate, etc.). Remove and keep them safe;
Also check that there is a power socket near the installation area
● Preparing the cabinet for installation:
• The product cannot be installed above cooling appliances, dishwashers, heaters,
ovens, washing machines and dryers; Create the cut-outs in the cabinet before
inserting the hob and carefully remove shavings or sawdust.
• to optimise the recirculating installation, it is recommended to create a slot in the
plinth, in which to insert a commercial grille.
• Important: use a single component adhesive sealant (S) that can withstand high
temperatures up to 250°; before installation, the surfaces that need to be glued
must be thoroughly cleaned, removing all substances that may compromise
adhesion (e.g. release agents, preservatives, grease, oils, powders, old adhesive
residue, etc.); the adhesive must be evenly spread along the entire perimeter of the
frame; after gluing, leave the adhesive to dry for about 24 hours.
● Note: for correct installation of the product, it is recommended to tape the pipes
using an adhesive with the following characteristics: soft elastic PVC film, with
acrylic-based adhesive; complies with DIN EN 60454 regulations; flame retardant;
excellent resistance against wear; resistant to temperature fluctuations; can be
used at low temperatures.
19

Publicidad

loading

Este manual también es adecuado para:

859991652180