Whirlpool WVH 92 K/1 Instrucciones De Uso página 63

acoustic signal.
Activation of the cooking zone timer function
• Touch (press) the Selection/Display area (2) (power
level other than zero)
• Press (6) relating to the cooking zone
• Use the symbols
Timer, which is shown in the Zone/Display (4); while
setting, the symbol (6) flashes.
Note: wait 10 seconds without pressing any other
command, so that the Cooking Zone Timer will start.
Note: by pressing and holding
zone Timer is reset.
If desired, repeat the operation for several cooking
zones:
Each cooking zone can have a different Timer set; in the
display (4) the countdown of the cooking zone selected at
that moment will appear; if no zone is selected, press the
Display (4) to view the STAND-ALONE Timer countdown.
When the timer has finished the countdown, an acoustic
signal sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the
hob is connected to the mains, or reconnected to the
mains, within the next 2 minutes.
To set the Power Limitation:
• press (which will flash, only for the first 2 minutes
after the product has been switched on)
• while continuing to hold down
time, all the Selection/Display areas (2) of the cooking
zones in a counter-clockwise direction starting from the
front left zone (FR); a short acoustic signal will be emitted
with each press and when all the Displays (2) have been
pressed, it will be possible to release the key:
at this point, the Display (2) of the rear left zone (RL) will
(5) to set the duration of the
(6) again, the cooking
, using
ON/OFF (1) button, when the
, press, one at a
show, in alternating sequence, the symbols
indicating that the setting can be made.
• select the Display (RL-2) then slide along the Selection
bar (3), until the Display shows the symbols
The Display (FL-2) will show the current setting with the
values in the table:
Displayed value
To change the Power Limitation setting:
• press the Display (FL-2) then slide along the Selection
bar (3), to
set the new setting. To save the selection made, press the
ON/OFF (1) button for 2 seconds; an extended
audible signal will be emitted to confirm the setting.
(5).
● Key Lock
The Key Lock allows you to lock the settings of the hob to
prevent accidental tampering with the same, while leaving
the set functions enabled.
Activation:
• press (10) Repeat the operation to deactivate.
Note: if any other function is pressed while the Key Lock is
active, the symbol
is in use and must be deactivated if necessary in order to
use the hob.
● Automatic Heat UP
The Automatic Heat UP function allows the set power to be
reached more quickly; with this function it is possible to
cook food faster without the risk of burning it, insofar as the
temperature does not exceed the set level. This function is
available for power levels from
Activation:
• with the cooking zone on, press
will show a flashing
the cooking zone.
By increasing the power level of the cooking zone: the
Automatic Heat Up function remains active, with the new
temperature setting;
By decreasing the power level of the cooking zone: the
Automatic Heat Up function is deactivated.
Note: by selecting another cooking zone at the same time,
24
and
Power (Kw)
7.4 Kw (default setting)
4.5 Kw
3.1 Kw
will flash to indicate that the function
to .
(7), the Display (2)
, alternating with the power set in
and ,
;