Descargar Imprimir esta página

Whirlpool WVH 92 K/1 Instrucciones De Uso página 59

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 99
OTHER USEFUL INFORMATION
The device may have different aesthetic features with respect to the illustrations in this handbook, however the
operating, maintenance and installation instructions remain the same.
USE
USING THE HOB
The induction cooking system is based on the physical phenomenon of magnetic induction. The main characteristic of this
system is the direct transfer of energy from the generator to the pot.
Benefits: When compared to electric hobs, your induction hob is: Safer: lower temperature on the glass surface. Faster:
shorter food heating times. More accurate: the hob immediately reacts to your commands. More efficient: 90% of the
absorbed energy is transformed into heat. Moreover, once the pot is removed from the hob, heat transmission is immediately
interrupted, avoiding unnecessary heat loss.
● Recommended pot bottom diameters
IMPORTANT: if the pots are not of the correct size, the cooking zones will not switch on. To see the minimum pot
diameters for each individual zone, consult the illustrated section of this manual.
● Cookware
Important:
Use only pots and pans bearing the symbol
to avoid permanent damage to the hob surface, do not use:
• cookware with a base that is not perfectly flat;
• metal cookware with an enamelled base;
• cookware with a rough base, to avoid scratching the hob surface;
• never place hot pots and pans on the surface of the hob's control panel.
●Pre-existing cookware
You can check if the pot material is magnetic simply by using a magnet. Pots are not suitable if they are not magnetically
detectable. The indications from the previous paragraph also apply here.
USING THE EXTRACTOR FAN
The extraction system can be used in the duct-out version with external evacuation, or in the recirculating version with
filtering and internal recirculation.
Duct-Out Version:
Vapours are exhausted outside via a series of pipes (to be purchased separately). Connect the product to wall-mounted
exhaust pipes and holes with a diameter equivalent to the air outlet (connecting flange). For more information on the pipes
and their dimensions see the page relating to accessories in the installation manual - Duct-Out version. The use of pipes and
outlet holes in the wall with a smaller diameter will reduce the extraction performance and drastically increase the noise level.
All responsibility in this regard is therefore denied.
For maximum extraction efficiency: • We recommend a maximum pipe route length of 7 linear metres. • We recommend
using no more than two 90° bends along the entire 7 linear metres • Avoid drastic changes in the ducting diameter, seeking
to maintain a diameter of Ø 150 mm (or a rectangular section of 222 x 89 mm).
Recirculating Version:
The extracted air will be filtered in special grease filters and odour filters before being sent back into the room. The product is
supplied with all parts necessary for standard installation, with the air outlet positioned in the front part of the plinth. The
product is equipped with a set of odour filters. For more information, see the page relating to accessories for the recirculating
version (in the illustrated part of this manual).
20

Publicidad

loading

Este manual también es adecuado para:

859991652180