After Using; Cleaning And Maintenance - Beem Espresso Perfect Crema Plus Manual De Instrucciones

BEEM - Elements of Lifestyle
NOTE
► The espresso cup and the glass should
be well preheated as preparation takes
place in several steps.
1. Pour the milk into the froth container and
froth up roughly one third of the milk. The rest
of the milk is only heated and remains liquid.
2. Pour the hot milk and the frothed milk into
the glass.
3. Place the glass onto the hotplate so that
the milk stays hot.
4. Take the espresso cup and make the es-
presso.
5. Pour the hot espresso down the side of
the glass through the milk froth. The espres-
so floats on the lower milk layer.

After using

1. Switch off the appliance and pull the plug
out of the mains socket.
2. Clean the appliance and the accessories
used as described in the section Cleaning
and care (page 23).

Cleaning and maintenance

Before beginning any work, pay attention to
the safety instructions in the section Safety
instructions (page 14)!
Cleaning the appliance
1. Wipe down the housing of the appliance,
the hotplate and the cup rest with a damp
cloth. Use washing-up liquid to remove any
stubborn stains.
2. Dry all parts of the appliance thoroughly
after cleaning.
Emptying/cleaning the strainer
insert
1. Take the strainer holder (7) with the
strainer insert (6) out of the appliance as de-
scribed in the section Removing the strain-
er holder (page 20).
2. Fold up the retaining bracket (14) on the
handle of the strainer holder (image B1).
3. Hold the strainer insert firmly with the
folded up retaining bracket and tap the used
coffee out of the strainer insert (6) over the
waste bin.
4. Remove the strainer insert (6) from the
strainer holder (7) and rinse the strainer in-
sert and strainer holder under running water.
Emptying/cleaning the drip tray
1. Remove the cup rest (10).
2. Raise the drip tray (9) slightly at the front
and carefully pull it out of the appliance to the
front.
3. Empty the drip tray and rinse out with
warm water.
4. Clean the cup rest (10) using a damp
cloth.
5. Install the drip tray and cup rest in the ap-
pliance again after drying.
Cleaning the steam nozzle
In order to avoid clogging, the steam nozzle
must be cleaned after each use.
1. Pull off the plastic cover of the steam noz-
zle and rinse the cover by hand or in the dish
washer.
2. Point the metal pipe (15) of the appliance
towards the drip tray and turn the electro
switch (4) to the position in order to rinse
milk and other residue out of the metal pipe.
3. Wipe down the metal tube with a damp
cloth.
NOTE
► If the metal tube has become clogged,
you can clear the clogging with a needle.
Descaling the appliance .
In order not to shorten the service life of the
appliance and impair the quality of the coffee,
the appliance must be descaled at regular
intervals. The intervals between descaling
depend on the water hardness (in the case
of hard water after 80 coffees; and soft water
after 150 coffees).
To descale the appliance, proceed as follows:
1. Fill the water tank with water and citric
acid (5% solution) up to the MAX mark.
EN 23