Instructions For Making Coffee; Operation And Use - Beem Espresso Perfect Crema Plus Manual De Instrucciones

Ocultar thumbs Ver también para Espresso Perfect Crema Plus:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 44
BEEM - Elements of Lifestyle
Before using for the first time
1.
Insert the hotplate (1) into the top and the
drip plate (9) with the rest (10) into the bot-
tom of the appliance.
2.
Move the selector switch (4) to standby
and insert the plug into the mains socket.
3.
Fill the water tank (17) to the
mark as described in the section Filling the
water tank (page 19).
4.
Install the strainer insert (6) without cof-
fee powder into the strainer insert holder (7)
as described in the section Installing the
strainer insert (page 20).
5.
Insert the strainer holder (7) into the ap-
pliance as described in the section Inserting
the strainer holder (page 20).
6.
Switch on the appliance as described in
the section Switching the appliance ON/
OFF (page 18).
7.
Place a sufficiently large cup or bowl on
the cup rest (10) under the screen carrier (7).
8.
Move the selector switch (4) to the
sition and allow the water to run through the
appliance.
NOTE
During the first pumping process, unu-
sual noises may be heard. These noises
will stop once the appliance is filled with
water.
9.
Move the selector switch (4) to standby
and pour out the water collected.
10.
Repeat the last steps until roughly half
the contents of the water tank has run
through the machine.
11.
Empty the drip tray as described in chap-
ter Emptying the drip tray (page 23).
12.
Clean the appliance as described in the
section Cleaning and care (page 23).
NOTE
When using for the first time, it is
possible that production-related additives
such as grease could cause slight odour or
smoke. This is completely normal. Ensure
sufficient ventilation.
Observe the following instructions to make
an aromatic espresso or coffee at just the
right temperature.
Preheat your cups on the hotplate.
— MAX —
Rinse out cold cups with hot water to pre-
heat them before use.
Fill the water tank with fresh water.
After heating up the appliance, allow hot
water to run through the strainer insert and
holder.
Leave the empty, cleaned screen insert
with screen carrier in the hot appliance to
heat up.
Experiment with the amount of coffee
powder until you find the flavour you prefer.
As a general rule, add approx. 7 grammes of
coffee powder for one cup of coffee/espresso
and approx. 14 grammes of coffee powder
for one large cup of coffee or two cups of
po-
espresso.
Try various different levels of grinding
fineness for the coffee powder. The grinding
fineness has an influence on the aroma and
the cream of the espresso.
If possible, use freshly ground coffee
powder to assure optimum flavour.
Press in the coffee powder lightly. If the
coffee powder is pressed too firmly, it may
become bitter and the percolation time in-
creases.
Empty and clean the strainer insert after
each use.
Clean and descale the appliance at regu-
lar intervals. A dirty and/or scaled appliance
impairs the aroma.
1.
Open the lid of the tank (18).
2.
Lift out the water tank (17) using the black
handle.
3.
Pour water up to the MAX marking.
4.
Install the tank (17) in the appliance again
and close the lid (18).
Instructions for making
coffee

Operation and use

filling the water tank
EN 19

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido