Beem Joy Cafe Manual De Instrucciones página 26

22 EN
Operating panel
Symbol Functions
Press the selector button (12)
1 x for a cup of Espresso
Press the selector button (12)
2 x for a double espresso or
two cups of espresso
Press the selector button
(12) for 3 seconds to prepare
a coffee/lungo/diluted black
coffee
Press the selector button (13)
1 x for a cup of cappuccino
Press the selector button (13)
2 x for a large cup of cappuc-
cino
Press the selector button (13)
for 3 seconds to prepare milk/
froth e.g., for hot cocoa
Press the selector button (14)
1x for a glass of latte mac-
chiato
Press the selector button (14)
2 x for a large glass of latte
macchiato
Press the selector button (14)
for 3 seconds to activate the
cleaning function
All functions end automatically or can be
ended prematurely by pressing the corre-
sponding selector button.
Operation and use
General instructions
Observe the following instructions to make
an aromatic espresso or coffee at just the
right temperature.
Rinse out cold cups with hot water to
‹
warm them up before use.
Warm up your cups on the resting plate/
‹
hotplate (1).
Fill the water tank with fresh water.
‹
After heating up the appliance, allow hot
‹
water to run through the strainer insert and
holder.
All manuals and user guides at all-guides.com
‹
with strainer holder in the hot appliance to
heat up.
‹
powder until you find the flavour you prefer.
As a general rule, add approx. 7 grammes of
coffee powder for one cup of coffee/espresso
and approx. 14 grammes of coffee powder
for one large cup of coffee or two cups of
espresso.
‹
fineness for the coffee powder. The grinding
fineness has an influence on the aroma and
the cream of the espresso.
‹
powder to assure optimum flavour.
‹
coffee powder is pressed too firmly, bitter
substances can get into the coffee and the
percolation time increases.
‹
insert after each use.
‹
ular intervals. A dirty and/or scaled appliance
impairs the aroma.
1. Swivel up the lid.
2. Remove the water tank (3) upwards.
3. Pour water up to the MAX marking.
4. Install the water tank (3) in the appliance
again and close the lid.
ATTENTION
►
talling. The valve on the underside of the
water tank may be damaged.
►
per edge of the water tank are inserted into
the recesses on the rear of the appliance.
1. Turn the nib on the wall of the strainer
insert (10, 11) towards the handle and install
the strainer insert into the strainer holder
(15).
BEEM - Elements of Lifestyle
Leave the empty, cleaned strainer insert
Experiment with the amount of coffee
Try various different levels of grinding
If possible, use freshly ground coffee
Press in the coffee powder lightly. If the
Empty and clean the strainer
Clean and descale the appliance at reg-
Filling the water tank
Do not tilt the water tank when ins-
Make sure that both holders on the up-
Installing the strainer insert
(image A1)