4. INSTALLATION STEPS
Installation Steps
Connect the plugs of the splitter end of the DC splitter
1
cable to each light bar on the first fixture and the last
fixture in the array for 2-foot wide fixtures, or the
furthest set of light bars in 4-foot wide fixtures (see the
examples below). Let the cable trunk ends hang loose.
2
Connect the trunk ends of the DC splitter cables to the first
and last ports on the 4-port DC manifold cable. For 24-bar
systems, also connect the manifold splitter cable to both
4-port DC manifold cables (see the examples below).
3
At this time the manifold location can be adjusted
to the optimal location within the reach limitation
of the splitter cables. DO NOT stretch the DC
splitter cables to the light bars too tightly, as this
can cause stress on the light bar connection.
Maintain a minimum of 1 inch (25.4 mm) of bend
radius in all cables at the connector.
PIPP Rack, 4' x 4' 6-Bar Fixture, 2-Fixture Array (12 Bars)
1
Pallet Rack 2' x 4' 4-Bar Fixture, 6-Fixture Array (24 Bars)
1
4
Connect the remaining DC splitter cable trunk ends
to the ports on the DC manifold cable(s). Complete
the cable management by securing loose cables and
manifolds with wire ties to the rack (4a and 4b).
Install a dust cap on any unused manifold ports.
5
1 in (25.4 mm)
3
2
2
4
2b
4
1
1
Baker's Rack, 2'x4' 3-Bar Fixture, 4-Fixture Array (12 Bars)
3
1
4
4
1
4a
4b
1
1
4
2
4
3
1
3
DC Manifold Splitter
2b
5
15