Publicidad
4. INSTALLATION STEPS
Power Supply Wire Hanger Installation Instructions
Unistrut, Pipe, or Square Hanger Kit
1
Take (2) mounting brackets and hang a bracket over the
support structure. Locate the holes for brackets on the
narrow side of PSU power supply, hold up the power supply
under the support structure under it.
2
While maintaining a firm grip on both, pinch the bottom
of the bracket inward and horizontally insert it into the
receiving holes on the PSU power supply, release the
tension of the bracket.
3
Lift the ends of the brackets up to a 90° angle. Repeat
above steps to install another bracket on the PSU
power supply.
Combo Mount Hanger Kit
Take (2) mounting hangers. Hang both brackets over the
1
support structure as shown.
2
Hold the power supply up to the hangers as shown.
3
Hook each hanger end onto the upper loops at each corner
of the power supply.
IMPORTANT: DO NOT mount the power supply vertically using wire-form type hangers. To mount the power supply vertically,
use a Surface Mount Kit secured to a flat surface.
IMPORTANTE: NO coloque la fuente de alimentación verticalmente utilizando perchas de forma de alambre. Para montar la
fuente de alimentación verticalmente, utilice un kit de montaje en superficie fijado a una superficie plana.
IMPORTANT: NE PAS monter l'alimentation électrique à la verticale en utilisant des supports de type fil de fer. Pour monter
l'alimentation électrique à la verticale, utilisez un kit de montage en surface fixé sur une surface plane.
2
1
4
2
1
3
3a
3b
19
Publicidad
