Publicidad
4. INSTALLATION STEPS
4.7 - STEP 7: (OPTIONAL) CONNECT THE DC DIMMING CABLE TO THE POWER SUPPLY AND THEN TO A
DIMMING CONTROLLER
The DC dimming cable uses a coaxial type A-code M12 3-pin connector to
connect the cable to the power supply. To install the DC dimming cable:
1
Remove the dust cap from the power supply dimming port and let it hang by
the chain.
2
Match up the connector end on the cable (female) to the power supply dimming
port (male) and twist the ring on the connector clockwise to tighten until hand-
tight. Check that the connector is securely attached.
4.8 - STEP 8: POWER AND TEST THE SYSTEM
Turn on AC power to the system. All light fixtures should be on and
1
at equal levels of maximum brightness.
If a dimming controller has been connected, test the light fixtures by
2
dimming to off and ramping back up to maximum.
THIS COMPLETES THE INSTALLATION!
If the system testing was not successful, please refer to Section 5 for Troubleshooting.
For additional assistance, please contact:
www.fluence.science/support-center/
or email
support@fluence-led.com
22
2a
2b
Publicidad
