Publicidad
4. INSTALLATION STEPS
4.5 - STEP 5: CONNECT THE DC MANIFOLD CABLE(S) TO THE POWER SUPPLY
IMPORTANT: Please be sure to match the EXACT light bar quantity per power supply to the BAR COUNT on Power Supply SKU label for
proper system performance. A differed bar count from SKU label would result in INCORRECT LIGHT OUTPUT from light bars.
IMPORTANTE: Asegúrese de aparear la cantidad EXACTA de barras de luz por la fuente de alimentación con el CONTADOR DE BARRAS en
la etiqueta SKU de la fuente de alimentación para un rendimiento adecuado del sistema. Un recuento de barras diferente al de la etiqueta
SKU daría como resultado una SALIDA DE LUZ INCORRECTA de las barras de luz.
IMPORTANT: Assurez-vous de faire correspondre la quantité EXACTE de barres lumineuses par alimentation électrique au NOMBRE DE
BARRES indiqué sur l'étiquette de référence de l'alimentation électrique pour une performance correcte du système. Un nombre de barres
différent de celui sur l'étiquette de référence entraînerait un FLUX LUMINEUX INCORRECT des barres lumineuses.
All DC manifold cables use a push-lock type M19 2-pin
connector to connect the cable to the power supply or
manifold splitter cable.
To Attach or Remove the Connectors:
1
To attach the connector, match up the keyed pins on the
cable (male to female) to the receptacle and push it on
until you hear a "click". Check that the connector is
securely attached.
2
To remove the connector, twist the ring on the base of
the connector counter-clockwise approximately a quarter
turn until it stops to release, and then pull straight out.
4.6 - STEP 6: CONNECT THE AC POWER CABLE TO THE POWER SUPPLY
All AC power cables use a push-lock type M19 3-pin
connector to connect the cable to the power supply.
The connection to power is available in several plug types for
receptacles, or in pigtails for direct wiring.
To Attach or Remove the Connectors:
1
To install the connector, match up the keyed pins on the
cable (male to female) to the receptacle and push it on
until you hear a "click". Check that the connector is
securely attached.
To remove the connector, twist the ring on the base of
2
the connector counter-clockwise approximately a quarter
turn until it stops to release, and then pull straight out.
20
1
2a
"CLICK"
1
2a
"CLICK"
2b
2b
Publicidad
