Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CEILING FAN WITH LIGHT
FIG 13
ELECTRICAL CONNECTION
CONNECT
CONNECT
13. (FIG 13) Make house wire connections. Follow diagram on the right and make sure that all exposed wires
are tightened by screw on terminal block.
Note:
a. The terminal block shown in graph is preinstalled on the mounting bracket.
b. After wiring is completed, gently push wires into hanger bracket with terminal block facing upward (if
applicable).
a. Slide receiver through hanger bracket as shown.
b. Plug the male connection of receiver wires into the female
connector of motor wires.
c.
Insert the infra-red sensor into the hole on the canopy.
d. Make fixture wire connection. Plug the male connector into
female connector and plug the male terminal into female terminal.
(Do not force it into wrong receptacle as it will cause damage.)
14. (FIG 14) Tuck the downrod into the canopy. Push the canopy
upwards, lining up the keyholes on the bottom with the screws in
the hanger bracket. Twist the canopy to lock it in place, then tigh-
ten the screws to secure it.
15. (FIG 15) Push the glass upwards and turn to install. Use the
reverse switch to have the fan turn in the opposite direction.
16. Turn ON the electric power at the main fuse or circuit breaker
box.
14
Publicidad
