The following are explicitly excluded from this warranty:
- deterioration due to normal use or consumption of the
product;
- accessories supplied with this product which are worn out
or used up through proper use (e.g. batteries, rechargea-
ble batteries, cuffs, seals, electrodes, light sources, attach-
ments and nebuliser accessories);
- products that are used, cleaned, stored or maintained
improperly and/or contrary to the provisions of the instruc-
tions for use, as well as products that have been opened,
repaired or modified by the buyer or by a service centre
not authorised by Medel;
- damage that arises during transport between manufacturer
and customer, or between service centre and customer;
- products purchased as seconds or as used goods;
- consequential damage arising from a fault in this product
(however, in this case, claims may exist arising from
product liability or other compulsory statutory liability pro-
visions).
Repairs or an exchange in full do not extend the warranty
period under any circumstances.
17. EMC Guidance
The ME EQUIPMENT or ME SYSTEM is suitable for home
healthcare environments
Warning: don't near active HF surgical equipment and the
RF shielded room of an ME system for magnetic resonance
imaging, where the intensity of EM disturbances is high.
Warning: use of this equipment adjacent to or stacked with
other equipment should be avoided because it could result
in improper operation. If such use is necessary, this equip-
ment and the other equipment should be observed to verify
that they are operating normally.
Warning: use of accessories, transducers and cables other
than those specified or provided by the manufacturer of
this equipment could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this
equipment and result in improper operation."
Warning: portable RF communications equipment (including
peripherals such as antenna cables and external antennas)
should be used no closer than 30 cm (12 inches) to any part
of the equipment, including cables specified by the
manufacturer. Otherwise, degradation of the performance
of this equipment could result.
Technical description
1. All necessary instructions for maintaining BASIC SAFETY
and ESSENTIAL PERFORMANCE with regard to electroma-
gnetic disturbances for the excepted service life.
2. Guidance and manufacturer's declaration -electromagne-
tic emissions and Immunity.
77