Stahlwille Manoskop 730N Instrucciones De Utilizacion página 34

5. If you are using a ratchet insert tool,
set this to the desired direction by
turning the control knob.
Removing insert tools
1. If the tool was attached in the
"normal" position, press the
QuickRelease button on the
underside of the wrench head (A).
2. If the tool was attached to the torque
wrench rotated through 180° , insert a
fine punch into the locating hole on
the upper side of the wrench head.
Depress the locking pin with the
punch (A).
3. Remove the insert tool (B).
34