Stahlwille Manoskop 730N Instrucciones De Utilizacion página 43

Adjusting for deviations in
cut-out value
You may return your torque wrench to
STAHLWILLE for adjustment. You will
then receive the tool back with a new
works calibration certificate.
You may adjust the torque wrench
yourself. In this case, however,
STAHLWILLE's accuracy guarantee is
void.
A torque tester of sufficient capacity and
accuracy is required for making
readjustments.
®
Every Manoskop has two adjusting
screws inside for readjustment purposes.
These are accessible with an Allen key,
size 2 mm, through two holes in the
housing.
The adjusting screw, which lies nearer to
the control knob, is primarily for adjusting
the lower end of the scale.
43