Publicidad
Idiomas disponibles
Idiomas disponibles
OMNIA M 3.2
•
Do not install the unit in the following places:
- Where there is mist cf mineral oil, oiIspray or vapors. Plastic parts may deteriorate, and cause them to come loose
or water to leak.
- Where corrosive gases (such as sulphurous acid gas) are produced. Where corrosion cf copper pipes or soldered
parts may cause refrigerant to leak.
- Where there is machinery which emits electromagnetic waves. Electromagnetic waves can disturb the control
system and cause equipment malfunction.
- Where flammable gases may leak, where carbon fiber or ignitable dust is suspended in the air or where volatile
flammables such as paint thinner or gasoline are handled. These types of gases might cause a fire.
- Where voltage fluctuates a lot, such as in factories.
- In vehicles or vessels.
- Where acidic or alkaline vapors are present.
•
This appliance can be used by children 8 years old and above and persons with reduced physical, sensory or mental
capabilities or lack cf experience and knowledge if they are supervised or given instruction on using the unit in a safe
manner and understand the hazards involved. Children should not play with the unit. Cleaning and user mainte nance
should not be done by children without supervision.
•
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufaturer or its service agent or a similarly qualified
person.
•
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste seperatelly for special
treatment is necessary. Do not dispose of electrical appliances as municipal waste, use separate colectlon facilities.
Contact your local goverment for information regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substance can leak into the groudwater and get Into the food chain,
damaging your health and well-being.
•
The wiring must be performed by professional technicians in accordance with national wiring regulation and this circuit
diagram. An all-pole disconnection device which has at least 3mm separation distance in all pole and a resldualcurrent
device (RCD) with the rating not exceeding 30mAshall be incorporated in the fixed wiring according to the national
rule.
•
Confirm the safety cf the installation area (wals, floors, etc.) without hidden dangers such as water, electricity, and
gas.Before wiring/pipes.
•
Before installation , check whether the user's power supply meets the electrical installation requirements of unit
(including reliable grounding , leakage ,and wire diameter electrical load, etc.). If the electrical installation require
ments of the product are not met, the Installation cfthe product Is prohibited until the product Is rectified.
•
When installing multiple air conditioners in a centralized manner, please confirm the load balance of the three-phase
power supply, and multiple units are prevented from being assembled into the same phase of the th hase power
supply.
•
Product installation should be fixed firmly, Take reinforcement measures, when necessary.
•
In order to ensure the safety of the product, please restart the unit at least once every 3 months, so that the unit can
carry out self-Inspection operation.
•
About Fluorinated Gasses
- This air-conditioning unit contains fluorinated gasses. For specific information on the type of gas and the amount,
please refer to the relevant label on the unit itself. Compliance with national gas regulations shall be observed.
- Installation, service, maintenance and repair of this unit must be performed by a certified technician.
- Product uninstallation and recycling must be performed by a certified technician.
- If the system has a leak-detection system installed, it must be checked for leaks at least every 12 months. When the
unit is checked for leaks, proper record-keeping of all checks is strongly recommended.
2 GENERAL INTRODUCTION
•
These units are used for both heating and cooling applications.They can be combined with fan coil units, floor heating
applications, low temperature high efficiency radiators, domestic hot water tanks (field supply) and solar kits (field supply).
•
A wired controller is supplied with the unit.
•
Room thermostat (field supply) can be connected to the unit (room thermostat should be kept away from heating source
when selecting the installation place).
22T÷30T
NOTE
Cod. 3QE47660 - Rev. 00 - 02/2022
85
EN
Publicidad
